| NXP QorIQ® T-series PowerPC Processor |
- Four dual-threaded e6500 cores built on Power Architecture technology
- Up to 1.8 GHz each, 6.0 DMIPS/MHz per core
Shares a 2 MB L2 cache
- Three levels of instructions: User, supervisor, hypervisor
- Hybrid 32-bit mode to support legacy software and transition to a 64-bit architecture
- Advanced power management saving modes include state retention during power gating
|
| Memory |
RAM
- 8 GB DDR3 ECC SDRAM (Expandable)
ROM
- 64GB eMMC Flash (Upgradable)
- 128Mb QSPI flash memory (optional)
- 512KB MRAM for secure/reliable boot and non-volatile storage.
|
| XMC (42.3) site |
Dual XMC Expansion Sites (VITA 42.3)
- Two XMC expansion sites
- PCIe Gen2 x4 interface per XMC
- Up to 15 W module power per site
- 20 LVDS / 40 Single-Ended rear I/O signals
- Supports application-specific I/O expansion
|
| Back Panel |
- ANSI/VITA 1.1 compliant P1 & P2 VME64x connectors
- 64-bit VME bus interface
- Processor control, interrupt and arbitration signals
- 4 × Gigabit Ethernet interfaces
- 2 × PCIe Gen2 x4 interfaces for XMC expansion
- 4 × RS-232 / RS-422 serial interfaces
- 2 × USB 2.0 interfaces
- 10 × LVTTL I/O and 25 × FPGA GPIO
- Power distribution (+5 V) and system management signals
|
| On Board Feature |
- System Management FPGA for board monitoring, reset sequencing, and health management
- 24-lane PCIe Gen2.0 Switch
- Reset and clock synthesizer, Temperature sensors and voltage monitoring ICs
- One-wire Authenticator and Power Good, Reset LEDs on board to monitor board health
|
| General Feature |
- Slot Pitch: 1 Inch Conduction Cooled
- Power Supply: +5VDC +/- 5% input from VME Connector
- Operating Temperature: -40°C to +85°C
- Form Factor: 6U VME (233.35mm X 160mm)
- Environment Specification: RoHS and REACH
- Compliant & CE*
|
| Operating System |
|
| Target Application |
- Mission Computers
- Radar Signal Processing Systems
- Electronic Warfare (EW) Systems
- Sensor Interface & Data Acquisition
- Rugged Embedded Computing
|
